More Information


ADT, CADFEM and ISimQ's "Technology Day"

On May 8th 2019, ADT, ISimQ and CADFEM hosted a "Technology Day" at the VCC Vogel Convention Center in Würzburg.

The event was a huge success, with a full day of lectures from leading figures in turbomachinery design.

Technology Day Recap

Technology Day was all about exploring the turbomachinery design and simulation process. Each speaker addressed a topic, from inverse design methods to CFD simulations and fluid dynamics. The Technology Day was aimed at project managers, development and simulation engineers as well as at researchers looking to develop, optimize or use turbomachines in their products and calculate them using numerical methods.

The technology day agenda can be found below. For further information on any of the talks, get in touch by by emailing or filling out the form on this page.

The Agenda

Time Speaker Subject
10:00 - 10:15 Georg Scheuerer, ISimQ Introduction & Overview
10:30 - 11:30 Prof. Mehrdad Zangeneh, ADT Turbomachinery Design with Inverse Methods - Theory and Application
11:30 - 12:30 Georg Scheuerer, ISimQ CFD Simulations with & for Turbo: From Geometry to Evaluation
12:30 - 13:30 Lunch break  
13:30 - 14:30 Klaus Schönborn, CADFEM Structural Mechanical Simulations - Strength, Modal Analysis & Rotor Dynamics
14:30 - 15:15 Thorsten Hansen, ISimQ Calculation of Fluid-Structure Interaction - Forced Response & Flutter
15:15 - 16:00 Barbara Neuhierl, CADFEM Multi-Disciplinary Optimization of Turbomachinery
16:00 End  
16:00 - 17:30   Possibility for individual discussions & program presentations

Technology Day Speakers


Prof. Mehrdad Zangeneh


Turbomachinery Design with Inverse Methods – Theory & Applications